top of page

Model: L-2140

Driving Mode: Dual hydraulic cylinders, chain drive

Engagement Release Mode: Single point manual lock release

Arm Assembly : Double threaded lifting pads with adaptor for SUV

Safety Mechanics:

Automatic arm locking device

Mechanical safety latch on each carriage with 5cm interval

Parachute valve under each cylinder in case of hydraulic hose fracture

Relief valve to prevent overloading

Overhead shut-off limit witch to prevent damage caused by lifting too high vehicles

Door opening protection rubber

Up-limit switch

Synchronization cable

Control System:

Lifting operation by pressing “UP” button on motor

SPECIFICATION:     

Capacity                                       4,000kg

Min. Height                                  120mm

Max. Lifting Height                     1,900mm

Overall Height                              3,640mm

Overall Width                               3,384mm

Width between Columns           2,760mm

Short Arm Length                       680mm – 1,020mm

Long Arm Length                        860mm – 1,300mm

Lifting Time                                 50 sec.

Lowering Time                             40 sec.

Motor                                            220v/60Hz/ 1Ph

 

Complete with front housing for turntables and rear slip plates for total wheel alignment

Mechanical safety latch every 80mm in each post

Drop speed control in case of hydraulic hose fracture

Relief valve to prevent overloading

Immediate triggering safety stud devices in the event a cable slackens or fails

ACCESSORIES:

                1 Unit 3 Tons Hydrau-Pneumatic Rolling Jack

                1 Set Turning Radius Gauge

 

SPECIFICATIONS:

Capacity                                            4,500kg

Min. Height                                       180mm

Max. Lifting Height                          1,830mm

Overall Length                                   5,800mm

Overall Width                                     3,300mm

Width between Columns                 2,740mm

Runway Width                                   500mm

Width between Runways                 980mm

Lifting Time                                       50 sec.

Lowering Time                                   40 sec.

Power Supply                                     220v//60Hz, 1Ph

Model: L-4045

Model: 400WSP

Engagement Release Mode: Pneumatic lock release

Platforms: Complete with front housing for turntables and rear slip plates for total  Wheel alignment

Safety Mechanism:

Mechanical locking teeth with automatic engagement and pneumatic release

Drop speed control in case of hydraulic hose fracture

Compensation valves for perfect platforms synchronization

Photocell device for level monitoring and for detection of any obstacle

Emergency stop button

Anti crushing safety device which stops the lift at a height of 200mm above the ground during lowering and requires a restart before continuing the descent, associated with an acoustic warning

SPECIFICATION:

 

               

Capacity                                           4,000kg

Min. Height                                     180mm

Max. Lifting Height                        1,870mm

Runway Length                               4,500mm

Runway Width                                635mm

Distance between Runaways        850mm

Air Supply                                         6-8 kg/cm

Lifting Time                                     55 sec.

Lowering Time                                 45 sec.

Power Supply                                   220v/60Hz/1Ph
bottom of page